Drying Oven

DZF-6020 Vacuum Drying Oven

DZF-6020 vacuum drying oven is widely used in biochemistry, chemical and pharmaceutical, health, agricultural scientific research, environmental protection and other research and application fields, for powder drying, baking and disinfection and sterilization of various glass containers. It is especially suitable for fast and efficient drying of heat-sensitive, easily decomposed, easily oxidized substances and complex composition items.

Overview

DZF-6020 vacuum drying oven is a large-volume container that can be set to keep the temperature constant and dry wet glassware. The temperature inside the DZF-6020 vacuum drying oven can be set with the control knob on the front panel. The actual temperature can be read directly by the attached thermometer. Because the boiling point of water is one centigrade, one temperature must make the glassware dry quickly. But when it is above 80 degrees, the vapor pressure of water is quite high, which is enough to dry the wet utensils quickly. Moreover, even in the quantitative analysis experiment, all the dried utensils must be used at room temperature, so the time required for the utensils with too high temperature to return to room temperature will be prolonged, so the DZF-6020 vacuum The operating temperature of the drying oven does not have to be set above the boiling point of water.
The DZF-6020 vacuum drying oven can also be used to dry chemicals. At this time, if small molecules adsorbed on the surface of the compound are to be removed, the temperature of the DZF-6020 vacuum drying oven must be set above 120 degrees Celsius Two hours of heating is enough to drive off the water molecules, so that the true weight of the object can be measured.
The DZF-6020 vacuum drying oven is powered by electricity, and wet items are conductive, so you should be careful not to leak electricity when using it. Therefore, the general drying oven must be grounded to ensure safety. If there is no ground wire, make sure that there is no leakage in the oven. If there is a slight leakage, try pulling out the socket and inserting the prongs in the opposite direction. If there is no leakage, use it carefully. If there is still leakage, then Should be disabled immediately.
DZF-6020 Vacuum Drying Oven

DZF-6020 vacuum drying oven box structure:

1. The inside of the DZF-6020 vacuum drying oven is made of mirror stainless steel argon arc welding, and the outside of the box is made of high-quality steel plates, which are beautiful in appearance and novel.
2. The DZF-6020 vacuum drying oven adopts a microcomputer P.I.D temperature controller with over-temperature partial protection and digital display, and has a timing function for accurate and reliable temperature control.
3. The hot air circulation system is composed of a fan that can rotate continuously at high temperature and a suitable air duct. Improve the temperature uniformity in the working room.
4. The temperature limit alarm system will automatically stop when the temperature exceeds the limit, ensuring the safe operation of the experiment without accidents.

Advantages of DZF-6020 vacuum drying oven:

1. The vacuum environment greatly reduces the boiling point of the liquid that needs to be expelled, so vacuum drying can be easily applied to heat-sensitive substances.
2. For samples that are not easy to dry, such as powder or other granular samples, vacuum drying can effectively shorten the drying time.
3. Various mechanical parts or other porous samples with complex structures are cleaned and then vacuum-dried, leaving no participating substances after drying.
4. It is safer to use. Under vacuum or inert conditions, the possibility of thermal explosion of oxides can be eliminated.
5. Compared with ordinary drying relying on air circulation, powdery samples will not be blown or moved by flowing air.
DZF-6020 Vacuum Drying Oven Advantages

Features

The performance of DZF-6020 vacuum drying oven:

1. Long vacuum maintenance time: Thirty days after vacuuming, the vacuum degree changes little.
2. The body is not afraid of being dropped or touched, can withstand drastic changes in vacuum degree, has good transparency and is light in weight.
3. It is sealed with a high-quality silicone rubber ring, and no sealing grease is required.
4. It is equipped with a special precision needle valve, which can be vacuumed or introduced gas or liquid in a vacuum state.
5. Air volume fine-tuning: The valve is a special precision needle valve, which can micro-adjust the air intake and exhaust volume to avoid blowing damage to stored items and protect the vacuum gauge.
6. Connect the exhaust pipe and the needle valve with a quick-change joint, so that the pipe connection can be connected with one plug.
7. Applicable ambient temperature: 0°C-80°C (corresponding to the heated crucible that can be placed on the ceramic partition inside the product).
8. For the corresponding product, the power supply can be introduced into the dryer, and heaters, stirrers or other electrical appliances can be used under vacuum conditions.
DZF-6020 Vacuum Drying Oven Structures

DZF-6020 vacuum drying oven cleaning method:

① After the daily production, the surface of the equipment and pipes are scrubbed with detergent each time, and then the detergent on them is wiped with drinking water, and the surface of the equipment and pipes are dried, and confirmed that they have been cleaned.
②If there are stains on the inner wall of the equipment, use a towel dipped in soap solution to wipe away the stains, rinse with drinking water until the lotion is colorless, and rinse with pure water once.
③Wipe off the accumulated fluid with a towel, scrub it with pure water, close the cabinet door, and turn on the steam to dry it for later use.
④ Open the drain valve, rinse with drinking water until the lotion is colorless, and then rinse again with pure water.

Specifications

Technical Parameter

Model DZF-6010 DZF-6020 DZF-6050 DZF-6090 DZF-6210 DZF-6500
PowerSupply 220V/50HZ
ShellMaterial Spray-paintAnti-corrosion
LinerMaterial 304StainlessSteel
Temp.Range RT+10~200°C
Max.Vacuum
Degree
0.098Mpa
Temp.Stability ±1.0°C
Temp.Analysis 0.1°C
WorkingTemp. +5~40°C
InputPower(W) 400 800 1400 2000 2400 2800
Chamber
Capacity(L)
8 25 55 90 215 215
Inner
Dimension(W*D*H,mm)
200*200*200 300*280*300 410*400*340 450*450*450 560*600*640 630*810*845
Overall
Dimension(W*D*H,mm)
600*400*430 620*500*480 720*570*540 770*620*710 730*730*1800 790*1030*1850
Shelves(Pcs) 1 2 3 4

Tips:

1. 110V/60Hz can be customized.

2. Stainless steel tray can be customized.

3. Any customized configuration is welcome.

TALK TO OUR TEAM

Send an inquiry.

Share your application, equipment model or technical question. We will help you find the information you need.

+8617324835373[email protected]

19/F, Block B, Guohong Mansion, Hi-Tech Development Zone, Zhengzhou City, Henan Province, China

Fields marked * are required.

Sending your inquiry…

Please wait. You will be redirected when your inquiry has been submitted.